Router(config)#hostname R1 R1(config)#no ip domain-lookup R1(config)#banner motd # Authorized Access Only - R1 Gateway IPv6 Router # R1(config)#interface GigabitEthernet0/0/0 R1(config-if)#description LAN Link to S1 R1(config-if)#ipv6 address 2001:db8:acad:1::1/64 R1(config-if)#ipv6 address fe80::1 link-local R1(config-if)#no shutdown R1(config-if)# %LINK-5-CHANGED: Interface GigabitEthernet0/0/0, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/0/0, changed state to up exit R1(config)#interface Loopback0 R1(config-if)# %LINK-3-UPDOWN: Interface Loopback0, changed state to down %LINEPROTO-5-UPDOWN: Line protocol on Interface Loopback0, changed state to up description Management Diagnostic Loopback R1(config-if)#ipv6 address 2001:db8:acad:99::1/64 R1(config-if)#no shutdown R1(config-if)#exit R1(config)#end R1# %SYS-5-CONFIG_I: Configured from console by console copy running-config startup-config Destination filename [startup-config]? Building configuration... [OK] R1#configure terminal Enter configuration commands, one per line. End with CNTL/Z. R1(config)#ipv6 unicast-routing R1(config)#end R1# %SYS-5-CONFIG_I: Configured from console by console copy running-config startup-config Destination filename [startup-config]? Building configuration... [OK] R1#show ipv6 interface GigabitEthernet0/0/0 GigabitEthernet0/0/0 is up, line protocol is up IPv6 is enabled, link-local address is FE80::1 No Virtual link-local address(es): Global unicast address(es): 2001:DB8:ACAD:1::1, subnet is 2001:DB8:ACAD:1::/64 Joined group address(es): FF02::1 FF02::2 FF02::1:FF00:1 MTU is 1500 bytes ICMP error messages limited to one every 100 milliseconds ICMP redirects are enabled ICMP unreachables are sent ND DAD is enabled, number of DAD attempts: 1 ND reachable time is 30000 milliseconds ND advertised reachable time is 0 (unspecified) ND advertised retransmit interval is 0 (unspecified) ND router advertisements are sent every 200 seconds ND router advertisements live for 1800 seconds ND advertised default router preference is Medium Hosts use stateless autoconfig for addresses. R1#show ipv6 neighbors IPv6 Address Age Link-layer Addr State Interface 2001:DB8:ACAD:1:200:CFF:FE6A:EA59 0 0000.0C6A.EA59 REACH Gig0/0/0 2001:DB8:ACAD:1:250:FFF:FE10:97D2 0 0050.0F10.97D2 REACH Gig0/0/0 R1#configure terminal Enter configuration commands, one per line. End with CNTL/Z. R1(config)#no ipv6 unicast-routing R1(config)#end R1# %SYS-5-CONFIG_I: Configured from console by console show ipv6 interface GigabitEthernet0/0/0 | include ND router advertisements ^ % Invalid input detected at '^' marker. R1#configure terminal Enter configuration commands, one per line. End with CNTL/Z. R1(config)#ipv6 unicast-routing R1(config)#end R1# %SYS-5-CONFIG_I: Configured from console by console copy running-config startup-config Destination filename [startup-config]? Building configuration... [OK] R1#ping 2001:db8:acad:1::999 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 2001:db8:acad:1::999, timeout is 2 seconds: ..... Success rate is 0 percent (0/5) R1#